Course name

Course category

Adjusting A Single Amplifier

The basic process of adjusting just one XTi amplifier in the Band Manager software.

Aux Port's Sleep & Amp Status

The Sleep and Amp Status features of the AUX Port of a DCi amplifier and shows how to configure these features.

BSS Audio BLU8v2 VCA Control

How to use BSS Audio BLU8v2 for VCA control of a Crown DriveCore Install Network amplifier.

Configuring BLU Link for 48/96kHz

How to switch between 48kHz (default) and 96kHz sampling rate for BLU link audio.

Configuring Continuous Load Monitoring

How to configure a DCi Network amplifier to monitor and report errors in output load impedance.

Factory Reset

How to perform a Factory Reset on a DCi Network amplifier.

Factory Reset

A walk through of a factory reset on an XLS Amplifier which fixes the no audio on the output issue that has been reported to our service centers.

Getting Started

A quick overview of the launching and population of HiQnet Band Manager software with XTi amplifiers.

Getting to Know

The Crown CDi DriveCore Series and it's feature set optimized for selective installed audio market segments.

Getting to Know

An overview of the DCi Amplifier family and the benefits and features of the series.

Getting to Know

An overview of the LevelMAX protection suite within the I-Tech HD amplifier.

How to Update Firmware

How to update firmware in a DCi Network Amplifier.

Identifying Amplifiers

The process of identifying XTi amplifiers in HiQnet Band Manager. This allows one to match the virtual amplifiers in the software with the hardware amplifiers in the real world.

Loading Device Files

How to load a JBL or other device file into an XTi amplifier using HiQnet Band Manager Software.

Mastering EQ Control

How to make changes to multiple XTi amplifiers using the HiQnet Band Manager software.

Monitoring & Reporting Input AC Line Errors

How to monitor and report errors based on the Input AC Line powering a DCi Network amplifier.

Routing Audio onto the BLU Link Bus

How to route audio from the analog inputs of a DCi Network amplifier onto the BLU Link BUS for distribution to other devices in the BLU link ring.

Setting Amp Channels to Auto Standby

How to configure independent amp channels to enter a low-power Auto Standby state based on user-adjustable settings.

Storing Device Files

How to save, load, and distribute amplifier Device Files.

Storing Presets

How to save, load, and distribute amplifier Presets.