Drivecore Installation
Drivecore Installation Training
Analog vs Network Comparison
7.5 minutes
This video compares and contrasts the different DriveCore Install models currently available.
DSP
7 minutes
This video shows a basic overview of the DSP features inside a DriveCore Install Network amplifier.
Analog Input Routing
5 minutes
This video shows how to route analog audio with a DriveCore Install Network amplifier.
BLU Link Input Routing
8 minutes
This video shows how to route BLU link digital audio with a DriveCore Install Network amplifier.
How to Select High Z (70V/100V)
3 minutes
This video shows how to configure a DriveCore Install Network amplifier for high impedance speaker loads (70V/100V).
Input Y & Bridge Mode Settings
5.5 minutes
This video shows how to configure a DriveCore Install Network amplifier for Input Y and Bridge modes.
Priority Input Routing
4.5 minutes
This video shows how to configure a DriveCore Install Network amplifier for redundant input sources.
Signal Generator
3 minutes
This video shows how to use the built-in signal and noise generator in a Crown DCi-N amplifier.