• Drivecore Installation Training

    • Analog vs Network Comparison

      7.5 minutes

      This video compares and contrasts the different DriveCore Install models currently available.

      Watch video

      DSP

      7 minutes

      This video shows a basic overview of the DSP features inside a DriveCore Install Network amplifier.

      Watch video

      Analog Input Routing

      5 minutes

      This video shows how to route analog audio with a DriveCore Install Network amplifier.

      Watch video

    • BLU Link Input Routing

      8 minutes

      This video shows how to route BLU link digital audio with a DriveCore Install Network amplifier.

      Watch video

      How to Select High Z (70V/100V)

      3 minutes

      This video shows how to configure a DriveCore Install Network amplifier for high impedance speaker loads (70V/100V).

      Watch video

      Input Y & Bridge Mode Settings

      5.5 minutes

      This video shows how to configure a DriveCore Install Network amplifier for Input Y and Bridge modes.

      Watch video

    • Priority Input Routing

      4.5 minutes

      This video shows how to configure a DriveCore Install Network amplifier for redundant input sources.

      Watch video

      Signal Generator

      3 minutes

      This video shows how to use the built-in signal and noise generator in a Crown DCi-N amplifier.

      Watch video